Jenn-Air JGC3115GS Instruction Sheet - Page 3

Tools and Parts Gather the required tools and parts necessary for correct Propane gas conversion. Tools needed ■■ Flat-blade screwdriver ■■ 3/32" (#0 [2.0 mm]) flat-blade screwdriver (screwdriver shaft must be a minimum of 21/2" [6.4 cm] long) ■■ Adjustable wrench ■■ 7.0 mm nut driver ■■ 7.0 mm wrench Parts supplied ■■ Propane gas orifice spud (W11027216) High Altitude Conversion To convert the cooktop for elevations above 6,560 ft (1999.5 m), order a High Altitude Conversion Kit. ■■ Part Number W11035431: Propane gas high altitude ■■ Part Number W11035432: Natural gas high altitude To order, see the "Assistance or Service" section of the Use and Care Guide. IMPORTANT: Gas conversions from Natural gas to Propane gas must be done by a qualified installer. Before proceeding with conversion, shut off the gas supply to the cooktop prior to disconnecting the electrical power. WARNING This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer's instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion or production of carbon monoxide may result causing property damage, personal injury or loss of life. The qualified service agency is responsible for the proper installation of this kit. The installation is not proper and complete until the operation of the converted appliance is checked as specified in the manufacturer's instructions supplied with this kit. WARNING Explosion Hazard Use a new CSA International approved gas supply line. Install a shut-off valve. Securely tighten all gas connections. If connected to propane, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column. Examples of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Failure to do so can result in death, explosion, or fire. Convert from Natural Gas to Propane Gas 1. Turn manual shut-off valve to the closed position. B A C A. To cooktop B. Shut-off valve (closed position) C. Gas supply line 2. Unplug cooktop or disconnect power. To Convert Gas Pressure Regulator B A C D A. Access cap B. Rear of cooktop C. Gas pressure regulator D. Gas flow 3. Determine the type of regulator you have: Style 1: The cap has a slot and "NAT" printed on it. Remove access cap by using a flat-blade screwdriver or coin, turning the access cap counterclockwise. 3