Jenn-Air JGC3215GS Instruction Sheet - Page 7

High Altitude Conversions IMPORTANT: You must convert Propane gas with Propane gas High Altitude Kit Part Number W11035431 or Natural gas with Natural gas High Altitude Kit Part Number W11035432. If you need to convert Propane gas to Natural gas high altitude or Natural gas to Propane gas high altitude, you must convert the pressure regulator. For this, follow steps 1 through 3 of the necessary conversion. Natural Gas Orifice Spud Chart for High Altitude Conversion See the chart in the Natural Gas High Altitude Conversion Instructions. Burner Locations 15" (38.1 cm) Models A A 6. To convert burners: ■■ Insert 7.0 mm nut driver down onto the gas orifice spud (C) and remove by turning it counterclockwise and lifting out. ■■ Set gas orifice spud aside. ■■ Replace with correct Natural gas orifice spud. See the Natural Gas Orifice Spud Chart. AB B C A D C B A. Center burner A. Rear burner B. Front burner 5. Remove all burner caps and burner bases. Be sure to keep the cap and base for each burner together. This will assure that the cap and base are reinstalled on the proper burner. A B Single Burner A. Cap B. Spreader C. Electrode A C Double Burner A. Cap B. Spreader C. Electrode B C D Dual Flame Burner A. Inner cap B. Outer cap C. Spreader D. Electrode Standard Burner A. Igniter electrode B. Orifice holder C. Orifice spud B Double Burner A. Igniter electrode B. Orifice holder C. Orifice spud D. Orifice simmer A C Dual Flame Burner A. Igniter electrode B. Orifice holder C. Orifice spud IMPORTANT: Place Propane gas orifice spuds in plastic parts bag for future use and keep with package containing literature. 7. Replace burner bases and burner caps. IMPORTANT: Be sure that the electrode aligns with the notch or hole in the burner base. The igniter electrode is ceramic and could break during installation of the burner base. A B C A. Burner cap B. Electrode C. Burner base 7