Jenn-Air JGCP436WP Installation Instruction - Page 10
Flame Height, To Adjust Flame Height - griddle
![]() |
View all Jenn-Air JGCP436WP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Flame Height The cooktop flame should be a steady blue flame approximately ¼" (0.64 cm) high. Dual Flame Burner A B 7. Remove console and set aside. 8. Remove the round gasket from the valve stem. 9. Put a control knob onto the valve stem of the burner you want to adjust. A. Upper (simmer) flame B. Lower flame Single Flame Burner 10. Turn the control knob to LO and light the burner using a butane extension lighter. To Adjust Flame Height: 1. Unplug cooktop or disconnect power. 2. Remove burner grates. 3. Remove the control knobs. 4. Pull cooktop forward to expose the control console screws on the side of the cooktop burner base. 5. Remove the 2 screws on each side of the cooktop burner base that hold the control console in place. 11. Remove the control knob. 12. Use a ¹⁄₈" x 4¼" flat-blade screwdriver to adjust the flame height. Tighten screw to reduce flame height. Loosen screw to increase flame height. NOTE: When you are converting to LP gas, the screw should be tightened down completely on the single output valves. The dual output valve should not be adjusted. A A. Console attachment screws 6. Disconnect wiring from the control console. On Griddle Models: Support the control console in the middle with one arm and disconnect the griddle switch connectors and the grill indicator light with the other hand. A B A. Single flame burner adjustment screw (on right side of valve) B. Dual flame burner adjustment screw (on left side of valve) 13. When finished adjusting the flame height, put a control knob back onto the valve stem and turn off the burner. 14. Remove the control knob. 15. Replace the round gasket. 16. Repeat steps 8 through 15 for any other burners that need adjustment. 17. Reinstall the control console. Support the control console in the middle with one arm and reconnect the griddle switch connectors and/or grill indicator light connector. B A A. Griddle switch connectors B. Grill indicator light connector 10
![](/manual_guide/products/jennair-jgcp430wp-installation-instruction-a944a0f/10.png)