Jenn-Air JGCP436WP Installation Instruction - Page 14
Strip Circuit
View all Jenn-Air JGCP436WP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Complete Installation 1. Refer to the "Make Gas Connection" section for properly connecting the cooktop to the gas supply. 2. Refer to the "Electronic Ignition System" section for proper burner ignition, operation, and burner flame adjustments. IMPORTANT: You may have to adjust the "LO" setting for each cooktop burner. Checking for proper cooktop burner flame is very important. The small inner cone should have a very distinct blue flame ¼" (0.64 cm) to ½" (1.3 cm) long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip. 3. Refer to "Complete Installation" in the "Installation Instructions" section of this manual to complete this procedure. STRIP CIRCUIT Griddle 120V Control Wiring Diagram To Cooktop Stand-Alone R P2-1 P1-1 OR/W 1320W/120V OR/W Lamp 120V BU W Rotary Control P1-3 W P1-4 V W RTD W WV V W P2-6 P1-6 OR/W 14