Jenn-Air JGCP548HL Installation Instructions - Page 4
Location Requirements
View all Jenn-Air JGCP548HL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Parts Supplied Check that all parts are included. ■■ Gas pressure regulator ■■ Burner grates ■■ Burner caps ■■ Griddle drip tray (on griddle models) ■■ Foam tape Parts Needed All models must be installed with a backsplash if installing at zero clearance to a combustible back wall. See the "Cabinet Dimensions" section in the "Location Requirements" section for installation requirements. To order, see the "Assistance or Service" section of the Use and Care Guide. Check local codes and consult gas supplier. Check existing gas supply and electrical supply. See the "Electrical Requirements" and "Gas Supply Requirements" sections. High Altitude Conversion To convert the cooktop for elevations above 6,560 ft (2000 m), order a High Altitude Conversion Kit. ■■ Part Number W11238043: High altitude kit NOTE: Both propane and natural gas conversions are included in the high altitude kit. To order, see the "Assistance or Service" section of the Use and Care Guide. NOTE: The cooktop is manufactured for use with Natural gas. To convert to Propane gas, see the "Gas Conversions" section. Location Requirements IMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air. ■■ It is the installer's responsibility to comply with installation clearances specified on the model/serial/rating plate. The model/serial/rating plate is located on the underside of the cooktop burner base. ■■ It is recommended that a 600 CFM (17.0 m3/hr) or larger vent hood be installed above the cooktop. ■■ It is not recommended that a microwave hood combination be mounted above the cooktop. Follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface. ■■ The cooktop should be installed in a location away from strong draft areas, such as windows, doors, and strong heating vents or fans. ■■ All openings in the wall or floor where cooktop is to be installed must be sealed. ■■ Cabinet opening dimensions that are shown must be used. Given dimensions are minimum clearances. ■■ Grounded electrical supply is required. See the "Electrical Requirements" section. ■■ Proper gas supply connection must be available. See the "Gas Supply Requirements" section. ■■ The cooktop is designed to be supported by a solid floor in the opening, not hung from the countertop by its side or rear flanges. ■■ The gas and electric supply should be located as shown in the "Gas and Electric Connection Locations" section so that they are accessible without requiring removal of the cooktop. ■■ Provide cutout in left rear corner of cutout enclosure as shown to provide clearance for gas inlet, power supply cord, and to allow the rating label to be visible. IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate, or sustain other damage. Mobile Home - Additional Installation Requirements The installation of this cooktop must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). When such standard is not applicable, use the Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes. In Canada, the installation of this cooktop must conform with the current standards CAN/CSA-A240-latest edition or with local codes. 4