Jenn-Air JGRP436WP Installation Instruction - Page 21
Natural Gas Conversion
View all Jenn-Air JGRP436WP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Natural Gas Conversion WARNING 4. Locate the gas pressure regulator at the left rear of the range. Tip Over Hazard A child or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults. 1. Turn the manual shutoff valve to the closed position. B A C A. To range B. Shutoff valve (closed position) C. Gas supply line 2. Unplug range or disconnect power. To Convert Gas Pressure Regulator 1. Remove screws from kick plate. B A A. Gas pressure regulator 5. Remove the gas pressure regulator cap by using a large flatblade screwdriver, turning the regulator cap counterclockwise. NOTE: Do not remove the spring beneath the cap. 6. Turn over the gas pressure regulator cap and reinstall on the regulator so that the hollow end faces out and the letters "NAT" are visible. A A. Kick plate B. Remove these screws. 2. Push up on kick plate to release plate from shoulder screws. 3. Gently lay kick plate aside to avoid scratching the stainless steel. 7. Tighten the gas pressure regulator cap by using a large flatblade screwdriver, turning the regulator cap clockwise. 8. Test the gas pressure regulator and gas supply line. The regulator must be checked at a minimum 1" (2.5 cm) water column above the set pressure. The inlet pressure to the regulator should be as follows for operation and checking the regulator setting: Natural Gas: Minimum pressure 6" (15.2 cm) WCP Maximum pressure 14" (35.6 cm) WCP. Gas Supply Pressure Testing Gas supply pressure for testing regulator must be at least 1" water column pressure above the manifold pressure shown on the model/serial rating plate. 21