Jenn-Air JGRP436WP Installation Instruction - Page 9
Make Gas Connection - installation
View all Jenn-Air JGRP436WP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
3. Drill two ¹⁄₈" (3.0 mm) holes that correspond to the bracket holes of the determined mounting method. See the following. Floor Mounting B Make Gas Connection WARNING A Wall Mounting B A. #12 x 1⁵⁄₈" screws B. Anti-tip bracket A A. #12 x 1⁵⁄₈" screws B. Anti-tip bracket 4. Using a Phillips screwdriver, mount anti-tip bracket to the wall or floor with the two #12 x 1⁵⁄₈" screws provided. Depending on the thickness of your flooring, longer screws may be necessary to anchor the bracket to the subfloor. Longer screws are available from your local hardware store. 5. Move range close enough to opening to allow for electrical connections to be made. Remove shipping base, cardboard or hardboard from under range. 6. Continue installing your range using the following installation instructions. Explosion Hazard Use a new CSA International approved gas supply line. Install a shut-off valve. Securely tighten all gas connections. If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column. Examples of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Failure to do so can result in death, explosion, or fire. 1. Assemble flexible connector from gas supply pipe to pressure regulator located in the middle rear of the range. 2. Apply pipe-joint compound made for use with LP gas to the smaller thread ends of the flexible connector adapters (see B and G in the following illustration). 3. Attach one adapter to the gas pressure regulator and the other adapter to the gas shutoff valve. Tighten both adapters. 4. Use a combination wrench and channel lock pliers to attach the flexible connector to the adapters. Check that connector is not kinked. A BC D E A. Gas pressure regulator B. Use pipe-joint compound. C. Adapter (must have ½" male pipe thread) D. Flexible connector HG F E. Manual gas shutoff valve F. ½" or ¾" gas pipe G. Use pipe-joint compound. H. Adapter 9