Jenn-Air JJD3027IM Installation Instructions - Page 6
Installation Instructions
View all Jenn-Air JJD3027IM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Electrical Requirements A copy of the above code standards can be obtained from: National Fire Protection Association 1 Batterymarch Park Quincy, MA 02169-7471 CSA International 8501 East Pleasant Valley Road Cleveland, OH 44131-5575 ■■ A 120 V, 60 Hz, AC only, 15 A fused, electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this warming drawer be provided. ■■ The model/serial/rating plate is located above the left-hand side receiving slide. The warming drawer must be removed to view the model/serial/rating plate. See the illustration below. A IMPORTANT: The warming drawer must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/ NFPA 70 or Canadian Electrical Code, CSA C22.1. If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate. A. Model/serial/rating plate INSTALLATION INSTRUCTIONS Install Warming Drawer WARNING Excessive Weight Hazard Use two or more people to move and install warming drawer. Failure to do so can result in back or other injury. WARNING 1. Turn off power supply. Using 2 or more people, move warming drawer close to its final location. Remove and discard shipping materials, tape, and film from the warming drawer. Remove and set aside racks and other parts from inside warming drawer. 2. Check that the warming drawer Temperature control knob is set to the OFF position. 3. Support the warming drawer on a sturdy surface level with the cutout opening. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 4. Plug the power supply cord into the grounded 3 prong outlet. 5. Slide the warming drawer over halfway into the cutout opening. 6. Open warming drawer and slowly push against the front panel to slide the drawer completely into the cabinet until the flanges on the front panel meet the cabinet face. 6