Jenn-Air JJW2427DS Dimension Guide - Page 3

JENN-AIR® DETAILED PLANNING DIMENSIONS 27" SINGLE WALL OVENS JJW2427D - 27" x 297⁄8" x 255⁄16" 3 of 5 OPENING/CLEARANCE DIMENSIONS A A MODEL # JJW2427D in cm A A Width of cabinet (min.) 27 68.6 B Width of cutout 251⁄2 64.8 C* Height of cutout (recommended) 28 71.2 D D A D H C* C* I B C* B D Top of cutout to bottom of upper cabinet door (min.) 23⁄16 5.5 E EF Bottom of cutout to top Gof lower cabinet door (min.) 11⁄2 3.8 F BoHttom of cutout to floor 32 81.3 G Depth of cutout (min.) 24 61.0 H Top of countertop to bottom of cutout (min.) 313⁄8 79.7 B E E J K A L E e e Me e I Top of cutout to underside of countertop (minC.) 25⁄8 6.7 J Bottom of cutout toDfloor (min.) 37⁄8 9.8 G G e Recommended junction box location *Will fit cutout height from 2615⁄16" (68.4 cm) to 297⁄16" (74.8 cm). e FRONT VIEW A e F F F AI SIDE VIEW I G ELECTRICAL REQUIREMENTS 240 volt, 20-amp fused, grounded circuit is required. A dedicated B circuit is required. The length of conduit provided is for serviceability. Do not cut the conduit. The junction box should be located 3" (7.6 cm) maximum below the support surface. Drill a 1" (2.5 cm) minimum diameter hole in the right rear or left rear corner of the support surface for access to the junction box. NOTE: For under counter installation, the junction box should be located in the adjacent right or left cabinet. Drill a 1" (2.5 cm) minimum diameter hole in an upper corner of the side wall for access to the junction box. A e e A e Ie BC Ce* C* H H e B B C* H D GB g gE g Jg J Power Supply Location gF g J UNDER COUNTER INSTALLATION (without cooktop installed above) BACK VIEW IMPORTANT: Dimensional specifications are provided for planning purposes only. Do not make any cutouts based on this information. Refer to the Installation Guide before selecting cabinetry, verifying electrical/gas connections, making cutouts or beginning installation. All Jenn-Air® appliances are appropriately UL, CUL or CSA approved. 8330AdZw615