Jenn-Air JMC3415ES Flush Installation Instructions - Page 7

IMPORTANT: The flanges of duct 5 go under duct 4. The front edge of the duct should be flush with the microwave oven itself and not the door. 3. Repeat steps 1 and 2 on right side of cabinet. Use the following chart and illustration to measure the distance between center of mounting rail holes. Use shims if measured distance is incorrect. 27" (68.6 CM) INSTALLATION 30" (76.2 CM) INSTALLATION 26Z\v" (66.7 cm) 29Z\v" (74.3 cm) Correct Incorrect Install Rails, Vent Deflectors, and Bottom Duct 1. Mark vertical line 1Z\v" (3.2 cm) in on left side of cabinet. Verify line is level. 11/4" (3.2 cm) 4. Remove protective film from vent deflectors. 5. Position 1 of the vent deflectors in the cabinet, flush with the top front edge of the opening. Drill pilot holes; then, fasten deflector with 3 #8-14 x Z\x" screws. Top vent deflector 2. Make sure notch is at bottom of rail. Position the rail marked L on the left side of the cabinet with the bottom edge resting on the cabinet floor. Verify rail is 1Z\v" back from the face of the cabinet before proceeding. Drill pilot holes. Attach mounting rail using 4 #8-14 x Z\x" screws. NOTE: Drive screws in the center of the holes in the mounting rail. 6. Center bottom duct in cabinet so that each side of duct is the same distance from the side walls and front of duct is M\," (2.2 cm) from front of opening. 7. Mark 4 holes on bottom duct for reference. PilPoiltothHooleles 7/8" (2.2 cm) PPiliolot Ht ohleosles Notches Left rail Right rail 8. Remove bottom duct from cabinet and drill pilot holes (2 per side) using marks made in Step 7. 9. Center bottom duct in cabinet, line-up with drilled pilot holes, and insert 4 #8-14 x Z\x" screws. Mounting rail 7