Jenn-Air JMC3415ES Flush Installation Instructions - Page 9
Assistance - installation guide
View all Jenn-Air JMC3415ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
6. Remove protective film from trim kit frame. Notch 7. Align trim kit frame studs with corresponding holes in mounting rails and snap into place. NOTE: Top and bottom studs are different distances from the edge, so the trim kit frame will install in only 1 way. Ensure notch is in the lower-left corner. Complete Installation 1. Install the turntable in the microwave oven. 2. Check the operation of microwave oven by placing 1 cup (250 mL) of water on the turntable and programming cook time of 1 minute at 100% power. 3. If the microwave oven does not operate: ■■ Check that a household fuse has not blown or a circuit breaker tripped. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. ■■ Check that the power supply cord is plugged into a grounded 3 prong outlet. ■■ See the Use and Care Guide for troubleshooting information. Installation is now complete. Save these Installation Instructions for future use. To Remove Trim Kit Frame Firmly grasp top of trim at vent area and pull away. Installed Microwave Oven ASSISTANCE Call your authorized dealer or service center. When you call, you will need the microwave oven model number and serial number. Both numbers can be found on the model and serial number plate which is located behind the microwave oven door on the front frame of the microwave oven. If you need additional assistance, call us at our toll-free number or visit our website listed in the Use and Care Guide. 9