Jenn-Air JS42PPDUDE Owners Manual 1 - Page 19

PERFORMANCE DATA SHEETS Water Filtration System Model P1WB2/P1RFWB2 Capacity 200 Gallons (757 Liters) Model P1WB2L/P1RFWB2L Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42, Standard 53, and Standard 401 for the reduction of contaminants specified on the Performance Data Sheet. This system has been tested according to NSF/ANSI Standards 42, 53 and 401 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42, 53, and 401. Substance Reduction Aesthetic Effects Chlorine Taste/Odor Particulate Class I* Contaminant Reduction Lead***: @ pH 6.5 / @ pH 8.5 Mercury: @ pH 6.5 / @ pH 8.5 Asbestos Cysts† Turbidity Alchor Atrazine Benzene Carbofuran Chlorobenzene Endrin Ethylbenzene Lindane MTBE O-Dichlorobenzene Tetrachloroethylene Toxaphene TTHM Styrene VOC Atenolol Trimethoprim Linuron Estrone Nonylphenol Influent Challenge Concentration 2.0 mg/L ± 10% At least 10,000 particles/mL Influent Challenge Concentration 0.150 mg/L ± 10% 0.006 mg/L ± 10% 107 to 108 fibers/L†† 50,000/L min. 11 NTU ± 10% 0.040 mg/L ± 10% 0.009 mg/L ± 10% 0.015 mg/L ± 10% 0.080 mg/L ± 10% 2.000 mg/L ± 10% 0.006 mg/L ± 10% 2.100 mg/L ± 10% 0.002 mg/L ± 10% MTBE 0.015 mg/L ± 10% 1.800 mg/L ± 10% 0.015 mg/L ± 10% 0.015 mg/L ± 10% 0.045 mg/L ± 10% 2.000 mg/L ± 10% 0.300 mg/L ± 10% 200 ± 20% 140 ± 20% 140 ± 20% 140 ± 20% 1400 ± 20% Maximum Permissible Product Water Concentration ≥50% reduction ≥85% reduction Maximum Permissable Product Water Concentration 0.010 mg/L 0.002 mg/L 99% 99.95% 0.5 NTU 0.002 mg/L 0.003 mg/L 0.005 mg/L 0.040 mg/L 0.100 mg/L 0.002 mg/L 0.700 mg/L 0.0002 mg/L 0.005 mg/L 0.600 mg/L 0.005 mg/L 0.003 mg/L 0.080 mg/L 0.100 mg/L 0.015 mg/L 30 ng/L 20 ng/L 20 ng/L 20 ng/L 200 ng/L Average % Reduction >97.5% 99.2% Average % Reduction >99.3% / >99.3% >96.4% / 90.8% 99% >99.99% >99.1% 97.6% 94.5% 96.6% 91.1% 99% 96.6% 99.9% 99% 90.6% 99.9% 96.4% >93.7% 99.5% 99.9% 99.7% 95.7% 96.1% 96.3% 90.6% 93.7% Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.89 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters). The compounds certified under NSF 401 have been deemed as "emerging compounds/incidental contaminants." Emerging compounds/incidental contaminants are those compounds that have been detected in drinking water supplies at trace levels. While occurring at only trace levels, these compounds can affect the public acceptance/perception of drinking water quality. ■ It is important that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. Property damage can occur if all instructions are not followed. ■ The disposable cartridge must be changed at least every 6 months. ■ Use replacement filter P1RFWB2L, Part #EDR3RXD1/EDR3RXD1B. 2015 suggested retail price of $49.99 U.S.A./$54.95 Canada. Prices are subject to change without notice. ■ The filter monitor system measures the amount of water that passes through the filter and alerts you when it is time to replace the filter. To learn how to check the water filter status, see "Using the Controls" or "Water Filtration System" in the User Instructions or User Guide. ■ After changing the water filter, flush the water system. See "Water and Ice Dispensers" or "Water Dispenser" in the User Instructions or User Guide. ■ These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary. ■ The product is for cold water use only. ■ The water system must be installed in compliance with state and local laws and regulations. ■ Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. EPA Est. No. 082047-TWN-001 ■ Refer to the "Warranty" section (in the User Instructions or User Guide) for the Manufacturer's limited warranty, name and telephone number. Application Guidelines/Water Supply Parameters Water Supply Potable City or Well Water Pressure 30 - 120 psi (207 - 827 kPa) Water Temperature 33° - 100°F (0.6° - 37.8° C) Service Flow Rate 0.5 GPM (1.89 L/min.) @ 60 psi. * Class I particle size: >0.5 to