Jenn-Air JS42SEDUDW Use and Care - Page 11

The disposable water filter should be replaced every 6 months OR earlier if the flow of water to the water dispenser or ice maker decreases noticeably. After changing the water filter, press and hold RESET for 2 seconds until the indicator display changes to 99%. See "Using the Controls." Water Filter Status Lights (non-dispenser models) The water filter status lights will remind you when it is time to order and replace the water filter. When the Order Filter light is on, it is almost time to change the water filter. When the Replace Filter light is on, a new water filter should be installed. The disposable water filter should be replaced at least every 6 months OR earlier if the flow of water to the ice maker decreases noticeably. After replacing the water filter, press and hold RESET FILTER for 3 seconds. The Good light will turn on when the filter tracking feature is reset. See "Using the Controls." Changing the Water Filter The water filter is located in the base grille below the freezer compartment door. It is not necessary to remove the base grille to remove the filter. 1. Remove the filter by pressing the eject button and pulling straight out on the filter cap. NOTES: ■ Avoid twisting the cap when removing the filter because this could cause the cap to come off. If this occurs, replace the cap and pull the filter straight out. ■ There will be water in the filter. Some spilling may occur. A B A. Eject button B. Filter cap 2. Remove the cap by turning it counterclockwise until it stops. IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter. 3. Align the ridge on the cap with the arrow on the new filter and turn the cap until it snaps into place. A B 4. Remove the covers from the O-rings. Be sure the O-rings are still in place after the covers are removed. 5. Place the cap (removed in Step 2) on the new filter. Align the ridge on the cap with the arrow on the filter. Turn the cap clockwise until it snaps into place. B C A A. Eject button B. Arrow on filter C. Ridge on cap 6. Push the new filter into the opening in the base grille. As the filter is inserted, the eject button will depress. The eject button will pop back out when the filter is fully engaged. 7. Pull gently on the cap to check that the filter is securely in place. 8. Flush the water system. See "Water and Ice Dispensers." Using the Ice Maker Without a Water Filter You can operate the ice maker without a water filter. Your ice will not be filtered. 1. Remove the filter by pressing the eject button and pulling on the cap. See "Changing the Water Filter" earlier in this section. 2. Remove the cap by turning it counterclockwise until it stops. IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter. 3. With the cap in a horizontal position, insert the cap into the base grille until it stops. 4. Turn the cap counterclockwise until the cap slips into the attachment slot. Then, turn the cap clockwise until it is in a horizontal position. NOTE: The cap will not be even with the base grille. A. Cover B. O-rings 11