Jenn-Air JUR248RWES Use and Care - Page 4

INSTALLATION INSTRUCTIONS Tools and Parts TOOLS NEEDED: Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. ■ Hand drill or electric drill (properly grounded) Brad point doweling drill bit ■ Phillips screwdriver ■ Scissors ■ Masking tape ■ Tape measure ■ Petroleum jelly PARTS NEEDED: Custom Overlay Door Panel-See "Overlay Panel-Rear View." Hardware (Optional) PARTS SUPPLIED: ■ Flat-head screws (8) ■ Overlay plates (2) ■ Round-head screws (8) ■ Overlay hooks (4) Install Overlay Hooks Using a Phillips screwdriver and eight flat-head screws attach the overlay hooks to the back of the overlay panel. See "Overlay Panel-Rear View," for overlay hook locations. A Custom Overlay Panel If you plan to install a custom overlay panel, you will need to create the panel yourself or consult a qualified cabinetmaker or carpenter. See dimension drawings for panel specifications. IMPORTANT: ■ The thickness of the wood overlay must be ³⁄₄" (1.91 cm). ■ Overlay panel must not weigh more than 20 lbs (9.07 kg). ■ Overlay panel weighing more than recommended may cause damage to your refrigerator. Overlay Panel-Rear View Create the custom overlay panel using the dimensions shown. 1 3.33 cm) 4 11.2 cm) A. Overlay hooks (4) Door Hinge Holes ■ The views of the top and bottom hinge pin hole show a righthand hinge. Mirror the image for a left-hand hinge. ■ We recommend using a C-clamp and two pieces of scrap wood (front and back) to help reinforce the overlay panel when drilling the hinge pin holes. 1. Using a ¹⁄₂" Brad point doweling drill bit, drill a ¹⁄₂" (1.27 cm) deep hole into the top of the overlay panel for the top hinge pin as shown. Top View ¹⁄₂" A (1.2 cm) Front Surface 29⁷⁄₈" (75.88 cm) 1.35 mm) Back Surface A A. Radius 5.0 1 3.33 cm) 4 2¹⁄₂" (6.4 cm) 23³⁄₄" (60.33 cm) A. Overlay hook locations