Jenn-Air JXW5036WS Installation Instruction - Page 12

Audible Signal Activation and Deactivation The audible signals can be activated or deactivated by pressing the "LIGHT" button for 5 seconds. ■ If the audible signal is activated, a tone will sound, and "Snd" will appear on the display for 3 seconds. ■ If the audible signal is deactivated, "Snd" will appear on the display for 3 seconds. Charcoal Filter (Recirculation Accessory) Inclusion and Exclusion When the charcoal filter is in use (recirculating mode), press and hold the POWER DECREASE and POWER INCREASE buttons at the same time for 5 seconds. "Able" will appear on the display for 3 seconds. If the charcoal filter is not used (vented mode), press and hold the POWER DECREASE and POWER INCREASE buttons at the same time for 5 seconds, "none" will appear on the display for 3 seconds. ■ When the charcoal filter has been excluded, the charcoal filter alarm is disabled. ■ The inclusion or exclusion of the charcoal filter must be selected while the lights and the fan motor are Off. Heat Sensor The control is equipped with a heat sensor that will turn on the blower to the highest speed if excessive heat occurs around the control area. ■ If the blower is On or Off, the blower will automatically set to the highest speed. "Auto" will appear in the display to indicate that the heat sensor has detected excessive heat. ■ When the blower is operating due to excessive heat detected by the heat sensor, the blower speed cannot be decreased. ■ When the temperature level on the hood drops to normal, the blower will return to its setting before the excessive heat was sensed. Light To operate the light: 1. Press the Light button to turn the light on to high. 2. Press the Light button again to turn the light to low. 3. Press the Light button a third time to turn the light off. Timer The timer can be set from 1 to 60 minutes. The default timer setting is 10 minutes. To use the timer: 1. Press the Timer button to enter the timer mode. After 5 seconds the default time will be automatically selected. 2. Press the POWER DECREASE and POWER INCREASE buttons while the display is flashing (5 seconds) to adjust to the desired time. Pressing the timer button again or waiting 5 seconds after selecting the desired time will start the timer countdown. 3. The timer can be canceled at any time by pressing the Timer button again. NOTE: During the timer setup, the Power Decrease and Power Increase buttons are dedicated to the timer. After the timer starts, the Power Decrease and Power Increase buttons can be used for other functions. Fan Speed Buttons Power Increase/On This button is used to turn the fan On or increase the fan speed. ■ The fan will turn On if the Power Increase button is pressed and the hood was Off. ■ An audible tone will sound when the fan reaches its highest speed. Power Decrease/Off ■ This button is used to turn the fan Off or to decrease the fan speed. RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filters before operating hood. Be sure lights are cool before cleaning the hood. Exterior Surfaces Clean the range hood with a mild detergent and soft cloth. To avoid damage to the exterior surface, do not use abrasive cleanser or steel-wool pads. Metal Grease Filters The filters should be washed frequently. Place metal filters in dishwasher or hot detergent solution to clean. Let filter dry thoroughly before replacing it. 12