Jenn-Air JXW8030WS Installation Instruction - Page 11

Light To operate the light: 1. Press the Light button to turn the light on to high. 2. Press the Light button again to turn the light to low. 3. Press the Light button a third time to turn the light off. Timer The timer can be set from 1 to 60 minutes. The default timer setting is 10 minutes. To use the timer: 1. Press the Timer button to enter the timer mode. After 5 seconds the default time will be automatically selected. 2. Press the POWER DECREASE and POWER INCREASE buttons while the display is flashing (5 seconds) to adjust to the desired time. Pressing the timer button again or waiting 5 seconds after selecting the desired time will start the timer countdown. 3. The timer can be canceled at any time by pressing the Timer button again. NOTE: During the timer setup, the Power Decrease and Power Increase buttons are dedicated to the timer. After the timer starts, the Power Decrease and Power Increase buttons can be used for other functions. Fan Speed Buttons Power Increase/On This button is used to turn the fan On or increase the fan speed. ■ The fan will turn On if the Power Increase button is pressed and the hood was Off. ■ An audible tone will sound when the fan reaches its highest speed. Power Decrease/Off ■ This button is used to turn the fan Off or to decrease the fan speed. RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filters before operating hood. Exterior Surfaces: To avoid damage to the exterior surface, do not use steel wool or soap-filled scouring pads. Always wipe dry to avoid water marks. Cleaning Method: ■ Liquid detergent soap and water, or all-purpose cleanser ■ Wipe with damp soft cloth or nonabrasive sponge, then rinse with clean water and wipe dry. Metal Grease Filter 3. Reinstall the filter by making sure the spring release handles are toward the front. Insert metal grease filter into upper track. 4. Pull the spring release handle down. 5. Push up on metal filter and release handle to latch into place. 6. Repeat steps 1-5 for the other filter. Non-Vented (recirculating) Installation Filters The charcoal filter is not washable. It should last up to 6 months with normal use. Replace with Charcoal Filter Kit Number W10272068. To replace charcoal filter: 1. Cover the grille that covers the blower motor with the charcoal filter so that the slots on the filter correspond to the pins on the sides of the motor grille. The filters should be washed frequently. Place metal filters in dishwasher or hot detergent solution to clean. Let filter dry thoroughly before replacing it. Turn off fan and lights. Allow halogen lamp to cool. 1. Remove each filter by pulling the spring release handle and then pulling down the filter. A A. Spring release handle 2. Wash metal filters as needed in dishwasher or hot detergent solution. AB C A. Charcoal filter B. Pins C. Blower motor 2. Turn the charcoal filter clockwise to lock it. 3. Repeat steps 1-2 on the other filter. 11