Jensen JN102 Installation Guide - Page 8
JN102 - tv tuner
UPC - 044476029639
View all Jensen JN102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
JN102 To Secondary AV Monitor 12 VDC Power and Ground Auxillary video display INPUT VIDEO ***SAeNeTAENntNeAnnFaONRoWteIRBEeLloEwSS FM MOD OPTIONAL *OPTIONAL RELAY BOX SIRSWB CHOKE Power Harness Item #3 RCA-Female Patch Cord RCA Male to Male LINE OUT VIDEO (Yellow) TO OPTIONAL ADDITIONAL MONITOR Line Out-L (White) Line Out-R (Red) Line Out-V (Yellow) UNIT (BACK VIEW) PODTVT TV ANTENNA To TV Antenna In Dome Light Power Source Accessory Harness - Optional (P/N:8010730) Power Harness Item #3 Red RCA (Audio Right) White RCA (Audio Left) Yellow RCA (Video) Power C onnector 4 Pin Clean the IR Receiver Window on the front of the VCP. Remove Adhesive Backing and Apply IR LED to IR "Y" Adapter for use with Non-Stereo Installations Item# 5 OPTIONAL Figure A 1) Make the connections to the vehicle for the 12 pin wiring harness. 2) Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB. 3) Pull the wire tie loop tight and cut off the excess. 4) Connect the 12 pin harness to the mating connector on the Video Monitor. 5) Connect power harness to vehicle's electrical system by tapping into an accessory hot line and a good ground. 6) Verify all functions of the System before final mounting of the finished assembly. 7) Mount and connect the Television antenna. (Optional) Note: A VCP or other A/V Component can be connected to the video monitor system using a second source component harness (purchased separately, part number: 8010730). This harness would plug into the Mini-Din connector on the main PCB as in steps 2 and 3 above. A/V Source Definitions: 1= AV1, VCP or VCP with TV Tuner (Mini-Din on main PCB) 2= AUX-IN (VCP, Game or future DVD etc...) 3= Built-in DVD 4= TV (TV Tuner) *NOTE: If the original relay box P/N SIRSWB is installed, it recommended that the antenna for the wireless FM Modulator be unplugged. See Figure A for antenna location. **NOTE: Extending the wireless antenna beyond its 12 inch length will cause the FM Modulator to exceed FCC limits for wireless transmission. When installing the unit position the antenna for best reception. -6-