Jensen MP6212 Instruction Manual - Page 7

MP6212 WIRING Antenna Connect the antenna plug from the existing antenna cable (some vehicles require an adaptor). Satellite Radio Audio In R (Red) L (White) Aux-in Ground Connect to ground terminal or clean, unpainted part of chassis. Memory/Battery Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected. White/Black Stripe Black Yellow White Gray/Black Stripe Satellite Radio In Fuse (15 amp fast blow ATO) Rear Line out Gray Blue Red R (Red) L (White) Power Antenna Connect to power antenna or amplifier. If not used, tape bare end of wire. Accessory/Ignition Connect to existing radio wire or radio fuse. FRONT SP REAR SP Gray Green/Black Stripe Green Purple/Black Stripe Purple Left Speaker (Front) Right Speaker (Front) Left Speaker (Rear) Right Speaker (Rear) NOTE: The amplifier in this radio is only designed for use with four speakers. Never combine (bridge) outputs for use with two speakers. Never ground negative speaker leads to chassis ground. Failure to wire exactly as shown may cause electrical damage to the radio. NOTE: Only connect speakers with a nominal impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit. 5