Jensen POWER 400 Operation Manual - Page 8

POWER Amplifiers Speaker Wiring The Speaker Wiring diagrams illustrate options for connecting one or two speakers. Observe the proper speaker polarity. NOTE: Power amplifiers can drive speakers with a nominal impedance range of 2~ 4-ohms. For maximum power, configure your speakers for a nominal 2-ohm load. NOTE: Do not overlook the use of the proper gauge speaker wire. The Power series of amplifiers require a minimum of 12-gauge wire. Power 900.1 Two Subwoofer One Subwoofer SPEAKER OUTPUT SPEAKER OUTPUT Power 400.2 Two Speakers 4 ohm nominal SPEAKER OUTPUT + LEFT - + RIGHT BRIDGED MODE MONO STEREO X-OVER FULL LPF HPF One Subwoofer 4 ohm nominal SPEAKER OUTPUT + LEFT - + RIGHT BRIDGED MODE X-OVER MONO STEREO FULL LPF HPF --++ 4 ohm 4 ohm --++ 4 ohm nominal Tri-Mode L Inductor X-OVER FULL LPF HPF C Capacitor SPEAKER OUTPUT + LEFT - + RIGHT BRIDGED C L 4 ohm nominal 6