Kenmore 3055 Use and Care Guide - Page 14

Setting

Page 14 highlights

Setting Oven Controls (cont'd) Broil Broiling is a method of cooking tender cuts of meat by direct heat under the broil element of the oven. Be sure you center your broiler pan directly under the broil element for best results. Arrange oven rack while oven is still cool. Position the rack as needed. The broiler pan and its insert allow dripping grease to drain and be kept away from the high heat of the broiler. DO NOT use the pan without its insert. DO NOT cover the insert with foil. The exposed grease could ignite. Should an oven fire occur, close the oven door and turn off the oven. If the fire continues, throw baking soda on the fire or use a fire extinguisher. DO NOT put water or flour on the fire. Flour may be explosive and water can cause a grease fire to spread and cause personal injury. To Set for Broiling: 1. Arrange the oven rack while oven is still cool. Position the rack as suggested in the Broil Rack Position Table below. , Press "----"will appear in display. 3. Press and hold the A or V until the desired broil setting level appears in the display. Press theA for HI broil or the V for LO broil. Most foods may be broiled at the HI broil setting. Select the LO broil setting to avoid excess browning or drying of foods that should be cooked to the well-done stage. 4. For optimum browning, preheat broil element for 3 =4 minutes before adding food. 5. Place the insert on the broil pan, then place the food on the insert (See Fig. 1). DO NOT use the broil pan without the insert or cover the insert with aluminum foil. The exposed fat could ignite. 6. Place the pan on the oven rack. Close the oven door when broiling. 7. Broil on one side until food is browned. Turn and broil food on 2nd side. Note: Always pull the oven rack out to the stop position before turning or removing the food. 8. When broiling is finished, press .... Broil Rack Position Table Rack Position Food category 1st rack position Medium steaks & hamburgers 2nd rack position Fish, medium-well steaks & pork chops 3rd rack position Well-done foods such as chicken & lobster Note: The broiler pan and the insert allows grease to drain and be kept away from the high heat of the broiler. DO NOT use the pan without the insert. DO NOT cover the insert with foil; the exposed grease could ignite. Grid "\\\ Broiler Pan Supplied with some models Figure 1 To Operate the Oven Light The interior oven light will automatically turn ON when the oven door is opened. Press the Oven Light Switch located on control panel to turn the interior oven light ON and OFF whenever the oven door is closed. The interior oven light is located at the upper left rear wall of the oven interior and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use. To change the interior oven light, see "Changing the Oven Light" in the General Care & Cleaning section. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22

Setting
Oven
Controls
(cont'd)
Broil
Broiling is a method of cooking tender cuts of meat by direct heat under the
broil element of the oven. Be sure you center your broiler pan directly
under
the broil element for best results.
Arrange oven rack while oven is still cool. Position the rack as needed.
The broiler pan and its insert allow dripping
grease to drain and be kept away
from the high heat of the broiler.
DO NOT use the pan without its insert. DO
NOT cover
the insert
with foil. The exposed grease could ignite.
Should an oven fire occur, close the oven door and turn off
the oven. If the fire continues,
throw baking soda on the fire or use a fire
extinguisher.
DO NOT put water or flour on the fire. Flour may be explosive
and water can cause a grease fire to spread and cause personal injury.
To Set for
Broiling:
1.
Arrange the oven rack while oven
is
still cool. Position the rack as
suggested
in
the Broil
Rack Position
Table below.
Press
"----"will
appear
in
display.
,
3.
Press and hold the A
or V
until the desired broil setting level
appears in the display. Press theA
for HI broil or the V
for
LO
broil.
Most foods may be broiled at the HI broil setting. Select the LO broil
setting to avoid excess browning
or drying of foods that should be
cooked to the well-done
stage.
4.
For optimum
browning,
preheat
broil
element
for
3
=4 minutes
before adding
food.
5.
Place the insert on the broil pan, then place the food on the insert (See
Fig. 1). DO NOT use the broil pan without the insert or cover the insert
with aluminum
foil. The exposed fat could ignite.
6.
Place the pan on the oven rack. Close the oven door
when broiling.
7.
Broil on one side until food is browned. Turn and broil food on 2nd side.
Note: Always pull the oven rack out to the stop position before turning or
removing the food.
8.
When broiling is finished,
press
....
Broil
Rack
Position
Table
Rack
Position
Food category
1st rack position
Medium steaks & hamburgers
2nd rack position
Fish, medium-well
steaks & pork chops
3rd rack position
Well-done
foods such as chicken & lobster
Grid
"\\\
Broiler
Pan
Supplied
with some
models
Figure
1
Note: The broiler pan and the insert allows grease to drain and be kept away
from the high heat of the broiler. DO NOT use the pan without the insert. DO
NOT cover the insert with foil; the exposed
grease could ignite.
To Operate
the Oven
Light
The interior oven light will automatically
turn ON when the oven door is opened.
Press the Oven Light Switch located on
control panel to turn the interior oven light ON and OFF whenever the oven door is closed.
The interior oven light is located at the upper left rear wall of the oven interior and is covered
with a glass shield held by a
wire holder. The glass shield must be in place whenever
the oven is in use. To change the interior oven light, see
"Changing the Oven Light" in the General
Care & Cleaning
section.
14