Kenmore 3055 Use and Care Guide - Page 5

Grounding instructions (e ectrgcn tiomn odeosn y) iMPORTANT: READ AND SAVE THESE iNSTRUCTiONS. This appliance is equipped with a 3-prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle. DO NOT cut or remove the grounding prong from this plug. For personal safety, this oven must be properly grounded. For maximum safety, the power cord must be plugged into a 120V--60 Hz. outlet that is correctly polarized and properly grounded. If a two-prong wall receptacle is the only available outlet, it is the personal responsibility of the consumer to have it replaced with a properly grounded three-prong wall receptacle installed by a qualified electrician. Avoid fire hazard or electrical shock. Do not use an adaptor plug, an extension cord, or remove grounding prong from electrical power cord. Failure to follow this warning can cause serious injury, fire or death. Grounding type wall receptacle -x Do not, under any circumstances, cut, I remove, or bypass| the grounding pron_) Do not under any circumstances cut or remove the third round grounding prong from the power cord plug. See the installation instructions packaged with this oven for complete installation and grounding instructions. Do not operate the oven using a two-prong adapter or an extension cord. Power supply cord with 3-prong grounding plug Oven ignition When you turn the oven on, the glow bar igniter begins to heat. When the lighter is hot enough, in less than 1 minute, the gas flows into the burner and is ignited. The igniter glows bright orange when hot. It cycles on and off with the thermostat and will glow whenever the burner is on. Do not attempt to light the oven burners during a power failure. The oven burner valves will not open up and will prevent the gas from flowing through the burner valves to the burners. In the event of a power failure, turn the Temperature Control knob to OFF. When power resumes, turn the Temperature Control knob back to desired temperature. _ii:iJ::iii_ ..i.l.i.i..... Conversion to Liquefied Petroleum Gas (or L. P. Gas) This natural gas range is designed to allow for conversion to Liquefied Petroleum (L. P.) Gas. Only a qualified service agent should perform the L. P. conversion. Contact the local gas provider for conversion. An L. P. Conversion Kit is supplied with this range and is located on the main back of the range. The kit contains installation instructions which must be read before and followed carefully when installing the kit. To avoid serious injury, any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by a qualified service agent.