Kenmore 4031 Use and Care Guide - Page 10

CONNECTING THE DRAIN HOSE •The drain hose should always be properly secured. Failure to properly secure the drain hose can result in flooding and property damage. • Do not install the end of the drain hose higher than 96 in. (244.8 cm) above the bottom of the washer. •The drain must be installed in accordance with any applicable local codes and regulations. • Make sure that the drain hose is not stretched, pinched, crushed, or kinked. NOTE: A drain hose extension kit is available if the drain hose is not long enough. Do not extend drain hose more that 6 feet, as this will cause poor draining (_f resulting in poor wash and spin performance. _DPra/iNn H52o1s5eEERx2t0e0n2siKon 1 Option 1" Standpipe f Elbow Bracket Option 2: Laundry Tub Ilii Elbow Bracket Tie Strap Drain Hose The elbow bracket should be installed near the end of the drain hose. Hang the end of the drain hose over the side of the laundry tub. Use tie strap to secure the drain hose in place. Option 3: Floor Drain f -_ IIII Drain Hose The elbow bracket should be installed near the end of the drain hose. Insert the end of the drain hose into the standpipe. Use tie strap to secure the drain hose in place. NOTE: •Total height of the hose end should not exceed 96 in. (244.8 cm) from the bottom of the washer. •The drain hose should be inserted no more than 8-12 inches into the standpipe. NOTE: If the drain hose is extended more than 4 inches beyond the end of the end of the elbow bracket, mold, or microorganisms could spread to the inside of the washer. Drain Hose Floor Drain Insert the end of the drain hose into the floor drain. Secure the hose to prevent it from moving. CONNECT TO THE POWER SUPPLY Washer should be plugged into a 120-VAC, 60-Hz. grounded 3-prong outlet. Plug in the washer. _ J 10