Kenmore 720-0670A Use and Care Guide - Page 10

5. Using (3) 5/32 x 1/2" screws and (3) 1/2" lock washers, securely attach side burner shelf to grill head. Fully tighten two screws from previous step. Secure side burner control panel to main control panel with screw removed in step 2. (Fig. 11) 6. Repeat steps 2 through 5 to install side shelf. Installing Side Burner Valve 1. Remove the two screws attaching side burner to underside of side burner shelf to make room to install side burner valve. See Figure 12 A inset. 2. Remove two screws and washers from side burner control valve face. Insert side burner valve control stem through hole in side burner control panel. See Figure 12 B. 3. Place side burner control knob bezel over side burner valve control stem. Secure bezel to control and valve with 2 screws removed in step 2. Push control knob onto valve control stem. See Figure 13. 4. Insert valve orifice tip into burner tube as shown in Fig. 12. Reattach burner to underside of side burner shelf with screws removed in step 1. 5. Plug ignition wire into igniter wire electrode on underside of burner(Fig.14). 6. Plug ignition wire into electrode under the side burner . (Fig. 14) Figure 12 A B Figure 13 When you have finished assembling grill, make sure that all screws and nuts are tight and secure. Installing Battery 1.Unscrew the ignition battery cap. (Found at farleft of control panel). 2.Install battery into ignition box with positive terminal facing outward. 3.Replace the ignition battery cap after the battery has been installed. (Fig.15) 3pcs: ¼ X ½'' 1pc: ¼ X ½'' Figure 14 Figure 11 Figure 15 200 300 100 50 150 50 FC 400 250 500 350 6 00 700 1pc: 5/32 X ½'' 10