Kenmore 7418 Use and Care Guide - Page 5

ROUGH-IN DIMENSIONS ._---_267/8" _1 (68.3 crn) 43/8" 1.2cm) m B ELECTRIC CONNECTION REAR ViEW 2 9116"---_ (6.5 cm) 13 1/2" 43 5/8' (11o.7cm) 36" L UNPACKING 1. Using the four shipping carton corner posts (two on each side), carefully lay the dryer on its left side and remove foam shipping base. To prevent damage, do not use the control panel or coin meter housing as a means to pick up or move the dryer. 2. Return the dryer to an upright position. FOAM SHIPPING PAD 3 314' (9.5 cm) 3/8" (0.96 cm) DIA. GAS I" (2.54 cm) 47 1/2" (120.7 cm) REVERSING DOOR SWING Your dryer is designed so the door swing may be reversed at any time without additional parts. Conversion is accomplished by transferring hinges to the opposite side of the cabinet. To change the direction of the door opening: 1. Open the dryer door. Remove the four hinge hole plugs from the left side of the door opening. Place nearby for future installation. DOOROPEN900 SIDE ViEW 4 318" (11.1 cm) OPTIONAL --_ VENTKNOCKOUT ,e_ 27' (68.6 cm) (Figure 1) NOTE: You may need a plastic knife to help pull out the plugs. Be careful not to scratch the paint. , Remove the four screws that secure the door hinges to the dryer front panel (see below). NOTE: Remove one screw from each of the two hinges first. Hold the door firmly before removing the last two screws. , Rotate the door 180 ° and reinstall the door hinges to the dryer front panel with the four screws. , Install the four hinge hole plugs in the open screw holes on the right side of the door opening. EZ3- (9.5 cm) REMOVE 4 SCREWS (ONE FROM EACH HINGE FIRST)