Kenmore 7749 Installation Instructions - Page 6

6. Assembly of Burner Heads & Burner Caps (for Deep Well Cooktop models only) Your range is shipped with the Burner Heads and Burner Caps in the correct locations. Packing material is located between the Burner Heads and Burner Skirts. a. Be sure to follow the Installation Instructions before i!i! i!iii¸ii!iii;:ii!ii;iiililiiii¸:iil!ii:liiiiiii iiiiii!i iiii!i installing and using your new range. b. Remove all packing tape from cooktop area. Remove all Burner Caps and Burner Heads. c. Discard all packing material located under Burner Heads. d. To replace Burner Heads & Caps, match the letters located under center of Burner Caps with the letters located inside Burner Heads (Fig. 1 ). e. Match the letters stamped on Burner Skirts with Burner Heads and Burner Caps (See Fig. 1). Replace the Burner Heads and Caps on cooktop (See Fig. 2). Carefully align the Electrodes into slot or hole of each Burner Head (Fig. 3). Note: The Burner Heads should sit fiat on Cooktop Burner Skirts. f. Unpack Burner Grates and position on the cooktop. )) )) i - Fig. 2 ( )))) ( Electrodes must align into slot or hole for each Fig. 3 Burner Head 6. Assembly of Burner Heads & Burner Caps (for Ceramic Glass Cooktop models only) Your range is shipped with the Burner Heads and Burner Caps in the correct locations. Packing material is located between the Burner Heads and Burner Skirts. a. Be sure to follow the Installation Instructions before installing and using your new range. b. Remove all packing tape from cooktop. Remove Burner Caps and Burner Heads (See Fig. 4). c. Discard all packing material located under all Burner Heads. d. To replace Burner Heads & Caps, match the letters located under center of Burner Caps with the letters located inside Burner Head (only positions A & F are marked with letters - See Fig. 5). Place all Burner Heads & Caps on the cooktop (See Fig. 4) while carefully aligning the Electrodes into slots or holes of the Burner Heads (Fig. 7). Note: The Burner Heads should sit flat on Cooktop Burner Skirts. e. Replace Bridge Burner Caps. These include one Bridge Burner Center Cap (rectangular shaped) and the two Bridge Burner End Caps (The Bridge Burner End Caps will fit either the front or rear Bridge Burner Head loca- tions). Make sure that the tabs located under the Bridge Burner Caps fall into the slots located in the Bridge Burner Head (See arrows in Fig. 6) and that all the Bridge Burner Caps lie flat and evenly on the Bridge Burner Head. f. Unpack Burner Grates. NOTE: Do not force End Burner Grates down on cooktop. Be careful to line up the 2 Grate Pins located on each of the 2 End Burner Grates into the Pilot holes located on top of the Burner Caps (See Fig. 8). Position Burner Grates on cooktop and check that all the Burner Grate legs lie on the glass surface. g. Place Center Burner Grate between the end Burner Grates. P _