Kenmore 7749 Installation Instructions - Page 8

Waist-High Burner (Self Clean Models) Lower Ove_ Bottom Air Shutter (Removable)j To remove the oven bottom, remove oven hold down screws at rear ofoven bottom. Pull up at rear, disengage front of oven bottom from oven front frame, and pull the oven bottom out of the oven. Remove burner baffle so that the burner flame can be observed. If the flame is yellow in color, increase air shutter opening size. (See "2" in illustration below.) If the flame is a distinct blue, reduce the air shutter opening size. To adjust loosen lock screw (see "3" illustration below), reposition air shutter, and tighten lock screw. Replace oven bottom. Oven Burner Tube Lock Screw (_Air Shutter ® Orifice Hood 11.Air Shutter-Broil Burner The approximate flame length of the broil burner is 1 inch (distinct inner, blue flame). To determine if the broil burner flame is proper, set the oven to broil. Model and Serial Number Location For sealed bumer ovens, the identification plate is located on the right-hand surface of the oven front frame at the storage or warmer drawer; or the lower panel area. When ordering parts for or making inquires about your range, always be sure to include the model and serial numbers and a lot number or letter from the identification plate on your range. Your identification plate also tells you the rating of the burners, the type of fuel and the pressure the range was adjusted for when it left the factory. Care, Cleaning and Maintenance Refer to the Use & Care Guide for cleaning instructions. If removing the range is necessaryforcleaning or maintenance, shut off gas supply. Disconnect the gas and electrical supply. If the gas or electrical supply is inaccessible, lift the unit slightly at the front and pull out away from the wall. Pull only as far as necessary to disconnect the gas and electrical supply. Finish removing the unit for servicing and cleaning. Reinstall in reverse order making sure to level the range and check gas connections for leaks. See page 3, step 1 for proper anchoring instructions. Before You Call for Service Read the "Before You Call" and operating instruction sections in your Use & Care Guide. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance. Refer to the warranty in your Use & Care Guide for our tollfree service number and address. Please call or write if you have inquiries about your range product and/or need to order parts. If the flame is yellow in color, increase air shutter opening size. (See "2" in illustration above.) If the flame is a distinct blue, reduce the air shutter opening size. To adjust, loosen lock screw (see "3" in illustration above), reposition air shutter, and tighten lock screw. 12.Make Sure Range is Level. Level the range by placing a level horizontally on an oven rack. Check diagonally from front to back, then level the range by either adjusting the leveling legs or by placing shims under the corners of the range as needed 13. After installation is complete, make sure all controls are left in the OFF position. 8 Open warmer drawer. Serial plate location is here