Kenmore 7853 Installation Instructions - Page 1

Kenmore 7853 - 30 in. Gas Manual

Get Kenmore 7853 - 30 in. Gas PDF manuals and user guides View all Kenmore 7853 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 1 highlights

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE. READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE. iNSTALLER. exactly, damage, If the information in this manual is not followed a fire or explosion may result causing property personal injury or death. FOR YOUR SAFETY: -- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. -- WHAT TO DO iF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. -- Installation and service must be performed bya qualified installer, service agency or the gas supplier. OVERALL DIMENSIONS 253/4" Refer to your serial plate for applicable agency certification • ALL RANGES CAN TiP e iNJURY TO PERSONS COULD RESULT e iNSTALL ANTI-TIP DEVICE PACKED WiTH RANGE • SEE iNSTALLATiON iNSTRUCTiONS Note." For appliances installed in the State of Massachusetts see page 2. FRONT VIEW 47-3/4" Maximum '[ 36 + 1/8" *Minimum to Side Wall -Side of oRnanEgiethe5r" "5"-_ Minimum 30" t--.r-- 36" ,, Cabinets on Either Side oMf inRimanugme. to 14-13"_1 Maximum Depth for Cabinets Above Range Top. .t----25" _ i i ii Clearances and Dimensions 1. Location--Check location where the range will be installed. Check for proper electrical and gas supply, and the stability of the floor. 2. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid and level. _- 30._ 0" Clearance Below Cooking Top and at Rear of Range. Provide Proper Fuel Type Before Proceeding: Your range is preset to operate on natural gas. DO NOT attempt to convert this range to LP/ Propane settings without the proper LP/Propane conversion kit provided with the range or obtained from your dealer. Follow all instructions provided with the LP Conversion Kit. pin 316259336revCEN SP(0611) EspaNol- P_ginas 9-16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
iNSTALLATiON
AND
SERVICE
MUST
BE
PERFORMED
BY
A QUALiFiED
iNSTALLER.
iMPORTANT:
SAVE
FOR
LOCAL
ELECTRICAL
iNSPECTOR'S
USE.
READ
AND
SAVE
THESE
iNSTRUCTiONS
FOR
FUTURE
REFERENCE.
If the
information
in
this
manual
is
not followed
exactly,
a
fire
or
explosion
may
result
causing
property
damage,
personal
injury
or death.
FOR
YOUR
SAFETY:
--
Do not
store
or use
gasoline
or
other
flammable
vapors
and
liquids
in
the vicinity
of this
or any other
appliance.
--
WHAT
TO DO
iF
YOU
SMELL
GAS:
•
Do not try
to light
any
appliance.
•
Do not touch
any electrical
switch;
do not use
any
phone
in
your
building.
•
Immediately
call
your
gas
supplier
from
a
neighbor's
phone.
Follow
the gas
supplier's
instructions.
•
If
you
cannot
reach
your
gas
supplier,
call
the
fire
department.
--
Installation
and service
must
be performed
bya
qualified
installer,
service
agency
or the
gas supplier.
OVERALL
DIMENSIONS
253/4"
'[
--
30"
Minimum
47-3/4"
Maximum
36 + 1/8"
t--.r--
*Minimum to
Side Wall
on Either
"5"-_
Side of
Range 5"
36"
_-
30._
Refer to your serial plate for
applicable agency certification
• ALL
RANGES
CAN
TiP
e iNJURY
TO PERSONS
COULD
RESULT
e iNSTALL
ANTI-TIP
DEVICE
PACKED
WiTH
RANGE
•
SEE
iNSTALLATiON
iNSTRUCTiONS
Note." For
appliances
installed
in the
State
of Massachusetts
see page
2.
FRONT
VIEW
Minimum to
,, Cabinets
on
Either Side
of Range.
14-13"_1
Maximum Depth
for Cabinets
Above Range Top.
.t----25"
_
i
i
ii
0" Clearance
Below
Cooking
Top
and
at
Rear
of Range.
Clearances
and
Dimensions
1.
Location--Check
location
where
the
range
will
be
installed.
Check for
proper
electrical
and
gas supply,
and
the stability
of the floor.
2.
Dimensions
that
are
shown
must
be
used.
Given
dimensions
provide
minimum
clearance.
Contact
surface
must
be solid
and
level.
Provide
Proper
Fuel
Type
Before
Proceeding:
Your
range is preset
to operate
on
natural
gas.
DO NOT attempt to convert this range to LP/
Propane settings without the proper LP/Propane
conversion
kit provided with the range or obtained from your dealer. Follow
all
instructions
provided with the LP Conversion
Kit.
pin 316259336revCEN
SP(0611)
EspaNol-
P_ginas
9-16