Kenmore 7937 Use and Care Guide - Page 14

° Remove the outer lower Decorative Screw from housing at area between freezer and refrigerator doors. (You will need this hole for the Middle Hinge Bracket). 30 ° Place Upper Hinge's Pin in the top of freezer door and line up the Upper Hinge with holes in top of refrigerator. Use the 3 bolts to replace Hinge. ,f © © ° Following illustration, flip the Middle Hinge Bracket (Flange will now be on top) and position on left side of refrigerator and re-attach with two bolts and a Phillips screw. ° Place refrigerator door down over pin on bottom hinge. ° Place washer between refrigerator door and middle hinge and re-attach Hinge Pin to Hinge Bracket with 1/4-in. socket wrench. NOTE: Bracket has been flipped, but Hinge Pin stays in the same orientation with its hexagona! end facing upward. Fig. 34 • Tighten bolts. Force-fit Top Hinge Cover over Top Hinge. Fig. 35 ° Replace cover from left side of refrigerator top onto the right of top to cover the holes. Cover is also force-fitted. Middle Hinge Bracket ° Place Decorative Screw into outer hole on right side of housing. ° Attach cover on the right side. Cover is force-fitted. ___ .... Screw Fig. 36 After changing doors, make sure that the corners of the Door Gaskets are not folded over. To ensure a good seal, apply a small amount of silicon grease on the corners of gaskets.. Fig. 37 Corners REATTACNING FREEZER DOOR ° Put freezer door down over the Hinge Pin on the Middle Hinge Pin Bracket. 15