Kenmore 9751 Use and Care Manual - Page 16

Setting the Clock Setting the Clock The pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash. Press . The display will stop flashing. Instructions To set the clock (example below for 1:30) 1. Press . "CLO" will appear in the display (Fig. 1). 2. Press 1 3 0 pads to set the time of day to 1:30 (Fig. 2). Press . The time of day will appear in the display (Fig. 3). PRESS 1 3 0 DISPLAY Fig. 1 Changing between 12 or 24 hour time of day display 1. Press and hold for 7 seconds until "12Hr" or "24Hr" appears in the display. for 7 seconds Fig. 2 2. Press to switch between the 12 and 24 hour time of day display. The display will show either "12Hr" (Fig. 4) or "24Hr" (Fig. 5). 3. Press to accept the change or press to reject the change. 4. Reset the correct time as described in To set the Clock above. Please or press Fig. 3 note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours. Fig. 4 Fig. 5 16