Kenwood DNN990HD Quick Start Guide - Page 30
Removing Procedure, Removing the trim plate, Removing the unit
View all Kenwood DNN990HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Quick Start Guide NOTE • Install the microphone as far as possible from the cell-phone. Removing Procedure Removing the trim plate 1) Engage the catch pins on the extraction key (accessory3) and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure. 3 Catch Lock Removing the unit 1) Remove the trim plate by referring to step 1 in "Removing the trim plate". 2) Insert the two extraction keys (accessory3) deeply into the slots on each side, as shown. 3 3) Lower the extraction key toward the bottom, and pull out the unit halfway while pressing towards the inside. NOTE • The trim plate can be removed from the top side in the same manner. 2) When the lower level is removed, remove the upper two locations. NOTE • Be careful to avoid injury from the catch pins on the extraction key. 4) Pull the unit all the way out with your hands, being careful not to drop it. EN 30