Kenwood DNX6180 Quick Start Guide - Page 25
GPS antenna, Microphone unit
UPC - 019048192714
View all Kenwood DNX6180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
DNX7180/DNX7480BT/DNX6980/DNX6180/DNX6040EX/DNX6480BT/DNX5180 GPS antenna GPS antenna is installed inside of the car. It should be installed as horizontally as possible to allow easy reception of the GPS satellite signals. To mount the GPS antenna inside your vehicle: 1) Clean your dashboard or other surface. 2) Peel the backing off of the adhesive on the bottom of the metal plate (accessory -). 3) Press the metal plate (accessory -) down firmly on your dashboard or other mounting surface. You can bend the metal plate (accessory -) to conform to a curved surface, if necessary. 4) Place the GPS antenna (accessory 0) on top of the metal plate (accessory -). 0 - Microphone unit 1) Check the installation position of the microphone (accessory =). 2) Remove oil and other dirt from the installation surface. 3) Install the microphone. 4) Wire the microphone cable up to the unit with it secured at several positions using tape or other desired method. = Fix a cable with a commercial item of tape. Peel the release coated paper of double-face adhesive tape to fix on the place shown above. • Depending on the type of car, reception of the GPS satellite signals might not be possible with an inside installation. • The GPS antenna should be installed at a position that is spaced at least 12 inch (30 cm) from cellular phone or other transmitting antennas. Signals from the GPS satellite may be interfered with by these types of communication. • Painting the GPS antenna with (metallic) paint may cause a drop in performance. Adjust the direction of the microphone to the driver. Continued 25