Kenwood DPX301 Instruction Manual - Page 32
Removing
View all Kenwood DPX301 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Removing the Unit Removing the Hard Rubber Frame (escutcheon) 1 Engage the catch pins on the removal tool© and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure. 2 When the lower level is removed, remove the upper two locations. • The frame can be removed from the top side in the same manner. Removing the Unit 1 Refer to the section and then remove the hard rubber frame. 2 Remove the Hex-head screw with integral washer (M4X8) on the back panel. 3 Insert the two removal tools© deeply into the slots on each side, as shown. 4 Lower the removal tool towards the bottom, and pull out the unit halfway while pressing towards the inside. • Be careful to avoid injury from the catch pins on the removal tool. 5 Pull the unit all the way out with your hands, carefully not to drop it. Lock Catch Accessory® Accessory® NN 32 I English