Kenwood KCA-DR300 Operation Manual - Page 9

impact the GPS reception. In this instance, please mount your device where there

Get Kenwood KCA-DR300 PDF manuals and user guides View all Kenwood KCA-DR300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

4. When adjusting the angle of mounting, make sure that the camera's view is parallel with the level ground, and the ground/sky ratio is close to 6/4. 5. When not using the recorder, follow the instructions below to remove the recorder from the holder. NOTE: ƒƒ To ensure the highest quality recordings, you are advised to place the recorder near the rear view mirror. ƒƒ Select an appropriate location for mounting the device in a vehicle. Never place the device where the driver's field of vision is blocked. ƒƒ If the car's windscreen is tinted with a reflective coating, it may be athermic and impact the GPS reception. In this instance, please mount your device where there is a "clear area." ƒƒ The system will automatically calibrate the G sensor of the device during start-up. To avoid G sensor malfunction, always turn the device on AFTER you mount it in the vehicle properly. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
8
4.
When adjusting the angle of mounting, make sure
that the camera’s view is parallel with the level
ground, and the ground/sky ratio is close to 6/4.
5.
When not using the recorder, follow the instructions below to remove the recorder
from the holder.
NOTE:
±
To ensure the highest quality recordings, you are advised to place the recorder
near the rear view mirror.
±
Select an appropriate location for mounting the device in a vehicle. Never place
the device where the driver’s field of vision is blocked.
±
If the car’s windscreen is tinted with a reflective coating, it may be athermic and
impact the GPS reception. In this instance, please mount your device where there
is a “clear area.”
±
The system will automatically calibrate the G sensor of the device during start-up.
To avoid G sensor malfunction, always turn the device on AFTER you mount it in
the vehicle properly.