Kenwood KCA-R71FM Instruction Manual - Page 20
Installation
UPC - 019048152114
View all Kenwood KCA-R71FM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
English Installation ■ Installation of Display unit • Installation without using the trim mount plate 3 Display unit Attach one strip of Velcro to the slanted-line of the display units as shown to the left, and attach the other strip of Velcro to the parts where you wish to attach the display units. Then, put velcros together and 2 install the display units. • Installation using the trim mount plate 3 Display unit ■ Installation of FM modulator unit 1 2CAUTION Take sufficient care so that the wires are not caught under the seat. If they are caught, they may break. Install the FM modulator unit beneath the front seat using Metal fixture and Bind head screw as shown in the above figure. 3 Pass the wire from the display unit through the hole on the trim mount plate and push fit the display unit into the trim mount plate until it locks. 2CAUTION • Be sure not to place the unit on such place as where it is exposed to direct sunlight and temperature eventually rises. It results in the deformation of the case. • Depending on the installing location, the display unit may not be able to receive the signals from the controller unit. Install them after confirming that the signals can be received. • Install the unit in such a way that it does not disturb driving. - 20 -