Kenwood KDC 132 Instruction Manual - Page 20
Troubleshooting Guide - rating
UPC - 019048164322
View all Kenwood KDC 132 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Troubleshooting Guide What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. General ? The power does not turn ON. ✔ The fuse has blown. ☞ After checking for short circuits in the wires, replace the fuse with one with the same rating. ? There's a source you can't switch. ✔ There's no media inserted. ☞ Set the media you want to listen to. If there's no media in this unit, you can't switch to each source. ? The memory is erased when the ignition is turned OFF. ✔ The ignition and battery wire are incorrectly connected. ☞ Connect the wire correctly, referring to the section on . ? Even if Loudness is turned ON, high-pitched tone isn't compensated for. ✔ Tuner source is selected. ☞ High-pitched tone isn't compensated for when in Tuner source. ? No sound can be heard, or the volume is low. ✔ The fader or balance settings are set all the way to one side. ☞ Center the fader and balance settings. ✔ The input/output wires or wiring harness are connected incorrectly. ☞ Reconnect the input/output wires or the wiring harness correctly. See the section on . ✔ The values of Volume offset are low. ☞ Turn up the Volume offset, referring to the section on (page 8). ? The sound quality is poor or distorted. ✔ One of the speaker wires is being pinched by a screw in the car. ☞ Check the speaker wiring. ✔ The speakers are not wired correctly. ☞ Reconnect the speaker wires so that each output terminal is connected to a different speaker. ? The Touch Sensor Tone doesn't sound. ✔ The preout jack is being used. ☞ The Touch Sensor Tone can't be output from the preout jack. Tuner source ? Radio reception is poor. ✔ The car antenna is not extended. ☞ Pull the antenna out all the way. ✔ The antenna control wire is not connected. ☞ Connect the wire correctly, referring to the section on . 20 | English