Kenwood KDC 135 Instruction Manual - Page 7

Speaker Setting Fine-tuning so that the System Q value is optimal when setting the speaker type. 1 Enter Standby Press the [SRC] button. Select the "STBY" display. 2 Enter Speaker Setting mode Press the [VOL] knob. 3 Select the Speaker type Turn the [VOL] knob. Each time you turn the knob, the setting alternates between the settings shown in the table below. Speaker type OFF For 5 & 4 in. speaker For 6 & 6x9 in. speaker For the OEM speaker Display "SP-F" "SP-5" "SP-6" "SP-O" 4 Exit Speaker Setting mode Press the [VOL] knob. Removing the Faceplate Press the Release button. The faceplate unlocks, allowing you to detach it. ¤ • The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. • Keep the faceplate in its faceplate case while detached. (Faceplate case: Accessory of KDC-135CR) • Do not expose the faceplate (and the faceplate case) to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. Reattaching the Faceplate 1 Align the projections on the unit with the grooves on the faceplate. Projections Grooves 2 Push the faceplate in until it clicks. The faceplate is locked in place, allowing you to use the unit. Clock Display Press the Control knob for at least 1 second. Each time you press the button, the clock display turns ON and OFF. Function of KDC-135 Subwoofer Output Turning the Subwoofer output ON or OFF. Push the Control knob toward [AM] for at least 2 seconds. Each time you push the knob, Subwoofer output switches ON and OFF. When it is ON, "On SUB" is displayed. Theft Deterrent Faceplate The faceplate of the unit can be detached and taken with you, helping to deter theft. TEL Mute The audio system automatically mutes when a call comes in. When a call comes in "CALL" is displayed. The audio system pauses. Listening to the audio during a call Press the [SRC] button. The "CALL" display disappears and the audio system comes back ON. When the call ends Hang up the phone. The "CALL" display disappears and the audio system comes back ON. ⁄ • To use the TEL Mute feature, you need to hook up the MUTE wire to your telephone using a commercial telephone accessory. Refer to (page 15). English | 7