Kenwood KDC-BT61U User Manual - Page 62
Accessories/ Installation Procedure, For Good Reception - protect
View all Kenwood KDC-BT61U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Accessories/ Installation Procedure Accessories 1 2 ..........1 3* ..........2 3 m ..........1 *Accessory of KDC-BT61U Installation Procedure 1 To prevent short circuits, remove the key from the ignition and disconnect the - terminal of the battery. 2 Make the proper input and output wire connections for each unit. 3 Connect the wire on the wiring harness. 4 Take Connector B on the wiring harness and connect it to the speaker connector in your vehicle. 5 Take Connector A on the wiring harness and connect it to the external power connector on your vehicle. 6 Connect the wiring harness connector to the unit. 7 Install the unit in your car. 8 Reconnect the - terminal of the battery. 9 Press the reset button. ¤ • Mounting and wiring this product requires skills and experience. For safety's sake, leave the mounting and wiring work to professionals. • Make sure to ground the unit to a negative 12V DC power supply. • Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. • Do not use your own screws. Use only the screws provided. If you use the wrong screws, you could damage the unit. • If the power is not turned ON ("Protect" is displayed), the speaker wire may have a short-circuit or touched the chassis of the vehicle and the protection function may have been activated. Therefore, the speaker wire should be checked. • Make sure that all wire connections are securely made by inserting jacks until they lock completely. • If your vehicle's ignition does not have an ACC position, or if the ignition wire is connected to a power source with constant voltage such as a battery wire, the power will not be linked with the ignition (i.e., it will not turn on and off 62 | KDC-BT61U/ KDC-6051U along with the ignition). If you want to link the unit's power with the ignition, connect the ignition wire to a power source that can be turned on and off with the ignition key. • Use a commercially available conversion connector if the connector does not fit in the vehicle connector. • Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. • If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening. • If the fuse blows, first make sure the wires aren't touching to cause a short circuit, then replace the old fuse with one with the same rating. • Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the - wires or ground them to any metal part in the car. • After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly. • Mount the unit so that the mounting angle is 30° or less. • Reception may drop if there are metal objects near the Bluetooth antenna. (KDC-BT61U only) Bluetooth antenna unit For Good Reception To assure good reception, note the following: • Communicate with the cell-phone within the line- of-sight distance of 10 m (30 ft). The communication range becomes shorter depending on the surrounding environment. The communication range also becomes shorter when there is an obstacle between this unit and the cell-phone. The above maximum communication range (10 m) is not always assured. • A broadcast station or walkie-talkie located nearby can interfere with communication due to too strong signal.