Kenwood KDC-HD548U Instruction Manual - Page 6
Getting started - reset
UPC - 019048192264
View all Kenwood KDC-HD548U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Getting started Canceling the display demonstration The display demonstration is always turned on unless you cancel it. When you turn on the power (or after you reset the unit), the display shows: [CANCEL DEMO] \ [PRESS] \ [VOLUME KNOB] 1 Press the volume knob. [YES] is selected as the initial setup. 2 Press the volume knob again to confirm. [DEMO OFF] appears. If no operation is done for about 15 seconds or if you turn the volume knob to select [NO] in step 2, [DEMO MODE] appears and the display demonstration starts. Setting the demonstration mode 1 Press the volume knob to enter [FUNCTION]. 2 Turn the volume knob to select [DEMO MODE], then press to enter. 3 Turn the volume knob to select [ON] or [OFF]. If [ON] is selected, display demonstration starts if no operation is done for about 20 seconds. 4 Hold to finish the procedure. Adjusting the clock 1 Press the volume knob to enter [FUNCTION] mode. 2 Turn the volume knob to select [SETTINGS], then press to enter. 3 Turn the volume knob to select [CLOCK], then press to enter. 4 Turn the volume knob to select [CLOCK ADJUST], then press to enter. Clock hour flashes on the display. 5 Turn the volume knob to adjust the hour, then press to enter minute adjustment. Clock minutes flashes on the display. 6 Turn the volume knob to adjust the minute, then press to confirm. Press 4 / ¢ to move between the hour and minute adjustment. 7 Hold to finish the procedure. Initial settings before operations 1 Press SRC to enter [STANDBY] mode. 2 Press the volume knob to enter [FUNCTION] mode. 3 Turn the volume knob to select [INITIAL SET], then press to enter. 4 Turn the volume knob to make a selection, then press to confirm. See table below for selection. 5 Hold to finish the procedure. Item Selectable setting (Preset: *) PRESET TYPE NORMAL*: Memorizes one station for each preset button in each band (FM1/ FM2/ FM3/ AM). ; MIX: Memorizes one station for each preset button regardless of the selected band (FM1/ FM2/ FM3/ AM). KEY BEEP ON*/ OFF: Activates/deactivates the keypress tone. BUILT-IN AUX ON1*: Outputs sound of the connected external component through the car speakers when "AUX" is selected as the source. ; ON2: Outputs sound from the connected external component when "AUX" is selected as the source. When you turn on the power, the sound attenuates (to prevent noise when no external component is connected). Turn the volume knob clockwise to return to the previous volume level. ; OFF: Disables "AUX" in source selection. 6