Kenwood KDC MP5032 Instruction Manual - Page 26

Menu system Other than Standby mode Audio Preset Memory Registering the value setup by Sound Control. The memory cannot be erased by the Reset button. 1 Setup Sound Control Refer to the following operations to setup the Sound Control. - (page 10) - (page 10) 2 Enter Menu mode Press the [MENU] button for at least 1 second. "MENU" is displayed. 3 Select Audio Preset mode Push the Control knob towards [FM] or [AM]. Select the "A- PRESET" display. 4 Enter Audio Preset mode Press the Control knob for at least 1 second. 5 Select the Audio Preset Memory Push the Control knob towards [FM] or [AM]. Select the "MEMORY" display. 6 Put the Audio Preset in the memory Press the Control knob for at least 2 seconds. The "MEMORY" display blinks 1 time. 7 Exit Menu mode Press the [MENU] button. • Register 1 pair of Audio Preset Memory. You cannot register by the source. • When you press the Reset, all the sources will be the setting value which is registered. • The following items cannot be registered. Volume, Balance, Fader, Loudness, Volume offset, Dual Zone System, Rear Volume Other than Standby mode Audio Preset Recall Recalling the sound setup registered by (page 26). 1 Select the source Press the [SRC] button. 2 Enter Menu mode Press the [MENU] button for at least 1 second. "MENU" is displayed. 26 | English 3 Select Audio Preset mode Push the Control knob towards [FM] or [AM]. Select the "A- PRESET" display. 4 Enter Audio Preset mode Press the Control knob for at least 1 second. 5 Select the Audio Preset Recall Push the Control knob towards [FM] or [AM]. Select the "RECALL" display. 6 Recall the Audio Preset Press the Control knob for at least 2 seconds. The "RECALL" display blinks 1 time. 7 Exit Menu mode Press the [MENU] button. • The User memory of (page 10) is changed to the value which was recalled. • The source tone memory item of (page 10) is changed to the value which was recalled by the selected source. In Standby mode Demonstration mode Setting Sets the demonstration mode. 1 Select the Demonstration mode Push the Control knob towards [FM] or [AM]. Select the "DEMO" display. 2 Set the Demonstration mode Press the Control knob for at least 2 seconds. Each time you press the knob at least 2 seconds, the Demonstration mode alternates between the settings shown in the table below. Display "DEMO ON" "DEMO OFF" Setting The Demonstration mode function is ON. Exit Demonstration mode (Normal mode).