Kenwood KDC-MP635 Instruction Manual - Page 9
Audio Setup - aux input
View all Kenwood KDC-MP635 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Bass Q Factor Bass Extend "BASS Q FACTOR" 1.00/1.25/1.50/2.00 "BASS EXT" OFF/ON Middle level Adjustment Item Display Range Middle Center Frequency "MIDDLE FRQ" 0.5/1.0/1.5/2.0 kHz Middle Q Factor "MIDDLE Q FACTOR" 1.00/2.00 Treble level Adjustment Item Display Treble Center Frequency "TREBLE FRQ" Range 10.0/12.5/15.0/17.5 kHz 5 Exit the Detail Audio Control mode Press the [VOL] knob for at least 1 second. ⁄ • When you set the Bass Extend to ON, low frequency response is extended by 20%. • You can exit the Audio Control mode at anytime by pressing any button except for [VOL] knob and [ATT] button. Audio Setup Setting the Sound system, such as Cross over Network. 1 Select the source to adjust Press the [SRC] button. Refer to (page 7). 2 Enter Audio Setup mode Press the [VOL] knob for at least 1 second. 3 Select the Audio Setup item to adjust Press the [VOL] knob. Each time you press the knob, the item to be adjusted alternates between the items shown in the table below. 4 Setup the Audio item Turn the [VOL] knob. Adjustment Item Front High Pass Filter Rear High Pass Filter Low Pass Filter Subwoofer Phase Display Range "HPF-F Fc" Through/40*/60*/80/100/120/ 150/180/220* Hz "HPF-R Fc" Through/40*/60*/80/100/120/ 150/180/220* Hz "LPF-SW Fc" 50*/60/80/100*/120/ Through Hz "SW PHASE" Reverse (180°)/ Normal (0°) Volume offset Loudness Dual Zone System "VOL-OFFSET" -8 - ±0 (AUX: -8- +8) "LOUD" OFF/ON "2 ZONE" OFF/ON ⁄ • * Function of KDC-X791/MP735U. • Volume offset: Sets each source's volume as a difference from the basic volume. • Loudness: Compensates for low and high tones during low volume. (Only the low tone is compensated for when the tuner is selected as a source.) • Dual Zone System Main source and sub source (Auxiliary input) output Front channel and Rear channel separately. - Set up the channel of sub source by (page 36). - Select Main source by [SRC] button. - Adjust the volume of Front channel by [VOL] knob. - Adjust the volume of Rear channel by (page 8). - The Audio Control has no effect on sub source. • You can use the Dual Zone System with the Auxiliary input sources listed below. - Internal auxiliary input. (KDC-X791/MP735U only) - CA-C1AX/ CA-C2AX (optional accessory) connected to this unit directly. (KDC-MP635 only) 5 Exit Audio Setup mode Press the [VOL] knob for at least 1 second. English | 9