Kenwood KDC-U2063 Operation Manual - Page 14

TROUBLESHOOTING INSTALLATION / CONNECTION Pandora ANDROID Symptom Cannot playback at [BROWSE MODE]. "NO DEVICE" or "READING" keeps flashing. Playback is intermittent or sound skips. "ANDROID ERROR" / "NA DEVICE" "ADD ERROR" / "SEARCH ERROR" "CHECK DEVICE" "NO SKIPS" "NO STATIONS" "STATION LIMIT" "CONNECT ERROR" "RATING ERROR" "LICENSE ERROR" Remedy • Make sure KENWOOD MUSIC PLAY APP is installed on the Android device. ( 8) • Reconnect the Android device and make the appropriate setting in [ANDROID SETUP]. ( 8) • If this does not solve the problem, the connected Android device does not support [BROWSE MODE]. ( 12) • Switch off the developer options on the Android device. • Reconnect the Android device. • If this does not solve the problem, the connected Android device does not support [BROWSE MODE]. ( 12) Turn off the power saving mode on the Android device. • Reconnect the Android device. • Restart the Android device. New station creation is unsuccessful. Check the Pandora application on your device. The skip limit has been reached. No stations are found. The number of registered stations has reached its limit. Retry after deleting unnecessary stations from your device. Communication is unstable. Registration of thumbs up/thumbs down has failed. You try to access from a country which Pandora is not deliverable. Warning • The unit can only be used with a 12 V DC power supply, negative ground. • Disconnect the battery's negative terminal before wiring and mounting. • Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire (black) to prevent a short circuit. • Insulate unconnected wires with vinyl tape to prevent a short circuit. • Be sure to ground this unit to the car's chassis again after installation. Caution • For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer. • Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot. • Do not connect the [ wires of speakers to the car chassis or Ground wire (black), or connect them in parallel. • Mount the unit at an angle of less than 30º. • If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red) to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned on and off by the ignition key. • Keep all cables away from heat dissipate metal parts. • After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly. • If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old fuse with one that has the same rating. Basic procedure 1 Remove the key from the ignition switch, then disconnect the [ terminal of the car battery. 2 Connect the wires properly. See Wiring connection. ( 16, 17) 3 Install the unit to your car. See Installing the unit (in-dash mounting). 4 Connect the [ terminal of the car battery. 5 Reset the unit. ( 3) 14