Kenwood KDC-X491 Instruction Manual - Page 30
Connecting Wires to Terminals - harness
View all Kenwood KDC-X491 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Connecting Wires to Terminals - 1 7"" , Sub Woofer left output (White) Sub Woofer right output (Red) AUX input (Stereo) Use the mini-plug which is stereo type and does not have any resistance. 18Ê FM/AM antenna input Front left output (White) Front right output (Red) Rear left output (White) Fuse (10A) Rear right output (Red) To Kenwood disc changer/ External optional accessory Wiring harness (Accessory1) To connect these leads, refer to the relevant instruction manuals. ," /Ê White White/Black Gray To front left speaker ," /Ê, Gray/Black Green To front right speaker , ,Ê Green/Black Purple To rear left speaker , ,Ê, Purple/Black To rear right speaker If no connections are made, do not let the wire come out from the tab. Power control wire (Blue/White) *° " / Motor antenna control wire (Blue) /° ÊÊÊ " / TEL mute wire (Brown) Ê1/ Dimmer control wire (Orange / White) 1 When using the optional power amplifier, connect to its power control terminal. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. Connect to the terminal that is grounded when either the telephone rings or during conversation. To connect the Kenwood navigation system, consult your navigation manual. To car light control switch Ignition wire (Red) Car fuse box ACC Battery wire (Yellow) Ground wire (Black) · (To car chassis) 30 | English ³ Ignition key switch Car fuse box (Main fuse) q Battery