Kenwood KRC-208S User Manual - Page 17
Connecting Wires to Terminals, circuit, that in turn may start a fire. Always connect those wires
View all Kenwood KRC-208S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Connecting Wires to Terminals KENWOOD disc changer control input (KRC-208S / 28MR only) NOTE To connect the Disc changer, consult your Disc changer manual. Rear left output (White) Rear right output (Red) Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle. P.CONT ANT. CONT. Fuse (10A) Wiring harness (Accessory1) Power control/Motor antenna control wire (Blue/White) Ignition key switch ACC Car fuse box (Main fuse) If no connections are made, do not let the wire come out from the tab. Car fuse box Ignition wire (Red) Battery wire (Yellow) Ground wire (Black) · (To car chassis) REAR • L FRONT • R FRONT • L FM/AM antenna input White/Black White Gray/Black Gray To front left speaker To front right speaker Green/Black Green To rear left speaker Purple/Black Purple To rear right speaker REAR • R Battery 2WARNING If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. 2CAUTION When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the - connector to a rear output terminal. - 17 -