Kenwood KVT-M707 Instruction Manual - Page 56
Security Code Setup
View all Kenwood KVT-M707 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Before Use Security Code Setup You can set a security code to protect your receiver system against theft. 2 Start the security code registration Set • When the Security Code function is activated, the code cannot be changed and the function cannot be released. Note, the Security Code can be set as the 4 digit number of your choice. 1 Display the Security Code Setup screen Security If Security touch or is not shown, to display it. 1 4 3 2 1 Security Code Set 5 DSI 6 On Of f 6 Pass Word 1 1 4 7 2 Clear 1st 2 3 5 6 8 9 0 3 Cancel 4 Enter 1 Enters the numbers to make your security code. 2 Clears your entry. 3 Cancels the registration and returns to the Security Code Setup screen. 4 Registers your security code. 3 Enter a security code 0 -9 Security 1 1 1 Adjusts the volume. 2 Returns to the Control screen of the previous source. 3 Calls the Sound Effects Menu. (see page 62) 4 Calls the Setup Menu. 5 Allows you to start security code registration. 6 Turns the DSI function on or off. If turned "On", the burglar alarm lamp flashes when the protection panel is removed. ( On) Input by four-digit number. 4 Register your security code Enter 5 Reenter the security code Reenter the same security code as that you have entered in Step 3 for confirmation. • If you have already completed the code registration, cannot touch S e t . • If you enter a different security code, the screen returns to Step 3 (for the first code entry). 6 Register the security code again Enter Now, your security code is registered. If you press the Reset button or if you disconnect your Receiver from the battery after the code registration, you need to enter the registered security code. See below for details. 56 | English