Kenwood MPV7019 Instruction Manual - Page 11
Enter Standby, Enter Speaker Setting mode, Select the Speaker type, Speaker type, Display
View all Kenwood MPV7019 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Adjustment Item Display Range Bass Center Frequency (KDC-X459 only) Bass level Bass Q Factor (KDC-X459 only) Bass Extend (KDC-X459 only) Middle Center Frequency (KDC-X459 only) Middle level Middle Q Factor (KDC-X459 only) Treble Center Frequency (KDC-X459 only) Treble level Balance Fader Volume offset "Bas F" "Bas"/"BAS" "BasQ" "BasEX" "MidF" "Mid"/"MID" "MidQ" "TreF" "Tre"/"TRE" "Bal"/"BAL" "Fad"/"FAD" "V-OFF" 60/70/80/100 or 150 Hz -8 - +8 1.00/1.25/1.50/2.00 ON/OFF 0.5/1.0/1.5/2.0 kHz -8 - +8 1.0/2.0 10.0/12.5/15.0/17.5 kHz -8 - +8 Left 15 - Right 15 Rear 15 - Front 15 -8 - ±0 • According to the Bass Q Factor setting value, the frequencies that can be set in Bass Center Frequency change as shown below. Bass Q Factor Bass Center Frequency 1.00/1.25/1.50 60/70/80/100 2.00 60/70/80/150 • When the Bass Extend is set to ON, low frequency response is extended by 20%. • Volume offset: Each source's volume can be set as a difference from the basic volume. 5 Exit Audio Control mode Press the [AUD] button. Speaker Setting Fine-tuning so that the System Q value is optimal when setting the speaker type. 1 Enter Standby Press the [SRC] button. Select the "ALL OFF" display. 2 Enter Speaker Setting mode Press the [Q] button. 3 Select the Speaker type Press the [4] or [¢] button. Each time the button is pressed the setting switches as shown below. Speaker type Display OFF For 5 & 4 in. speaker For 6 & 6x9 in. speaker For the OEM speaker "SP OFF" "SP 5/4" "SP 6*9/6" "SP OEM" 4 Exit Speaker Setting mode Press the [Q] button. - 11 -