Kenwood TK-3101K Instruction Manual - Page 16
transceiver, nAtup
View all Kenwood TK-3101K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
• QT Tone Setup Note: • Refer to the signalling codes listedin the table onpage 8. • When selecting a single digit number (0 - 9), always use 2 digits (00 - 09). • Whenyouare confirming the selectedsignalling number, there is a shortpause between the 10's digit andthe 1s digit. The transceiver will exit the nAtup mode if no operation is performed within 5 seconds. 1 Press and hold the PTT switch and Monitor key, then turn the power (-I`\ ON. Gil • Continue to hold the PTT switch and Monitor key until the LED lights orange, then release the keys. 2 Press the Monitor key. • The LED changes from orange to green and a beep sounds. The transceiver is now in QT tone setup mode. r, 3 Rotate the Channel selector to choose the channel you want to set up. .O:1S=MMIEtatiiiMac.. f. i 9