Kenwood TK-3101K Instruction Manual - Page 20

CHANNEL SETTING CONFIRMATION i You can confirm the signalling code settings that are programmed in your transceiver. Note: • After confirming a setting, you must turn the power OFF and then ON again so the transceiver can operate normally • There is a shortpause between the confirmation of the 10's digit and the confirmation of the 1'c digit 1 Select the channel you want to confirm. 2 Press and hold the Monitor key, then turn the power ON. • The beep pattern will sound. [i.e.- If QT tone 01 is set up on the channel, a 1 second tone will sound (0), there will be a short pause, and then a short beep will sound (1).] 3 Turn the power OFF after confirming the number. 4 Repeat steps 1 to 3 to confirm the OT tone of another channel. Beep Pattern Table: _ . ,,N,, tuntlw se. .,ps 0 1 second tone 1 • 2 .• 3 • • 9 4 5 6 _• 7 _•• 8 _••• 9 44444 titowmgm 13 oufi