Kenwood TK3101K2 Instruction Manual - Page 19
ista5, wzonrxamo
View all Kenwood TK3101K2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
9 Press the Monitor key again to confirm the beep pattern of the selected signalling number. 10 Repeat steps 3 to 9 to set up another channel. Example of setting up a channel with OT tone no. 01: 1 After entering OT tone setup mode, select channel 1. 2 Press and hold the PTT switch until a 1 second tone sounds, to select 0 for the 10's digit (approximately 2 seconds). 3 Wait for 2 seconds. • A 1 second tone will sound to confirm that 0 has been selected. 4 Press the PTT switch 1 time to select 1 for the 1's digit. • A beep sounds when you press the PTT switch. 5 Wait for 2 seconds. • A short beep will sound to confirm that 1 has been selected. 6 Press the Monitor key. ▪ The green LED blinks twice. 7 Press the Monitor key again. • A 1 second tone will sound (0), there will be a short pause, and then a short beep will sound (1) to confirm that 01 has been selected. ista5 12 wzonrxamo