Kenwood TS-570D User Manual - Page 13

3 GETTING ACQUAINTED PF ATT PRE-AMP VOX PROC SEND AT TUNE HF TRANSCEIVER TS-570D PHONES MIC CH1 CH2 CH3 123 ANT REC FINE 456 NB AGC/TONE REV 789 F.LOCK CLR 0 ENT MIC LSB USB PWR CW FSK KEY FM AM DELAY MENU 1MHz !2 !4 !5 !6 !3 UP DOWN MR M.IN - SPLIT TF-SET A/B RIT M/V A=B CLEAR XIT SCAN M>VFO M.IN N.R. DSP SLOPE HIGH LOW LOW CUT B.C. CW TUNE FILTER RIT/XIT AF RF 4 6 + 2 0 CH IF SHIFT 4 8 10 SQL 6 2 0 8 10 • REV button In CW or FSK mode, press to select either the upper or lower sideband while receiving {pages 21, 26}. • CLR button Press to exit from, abort, or reset various functions. Also used for erasing memory channels {page 43} or for locking out memory channels from the scan list {page 44}. • F.LOCK button Press to switch ON or OFF the Frequency Lock function {page 48}. • ENT button Press to enter the desired frequency via the keypad {page 29}. !2 Transmit function buttons Used in conjunction with the MULTI/CH control to set various transmit functions. • MIC button Used for setting the microphone gain level {page 15}. • PWR button Used for setting the transmit output power {page 15}. • KEY button Used for setting the internal electronic keyer speed {page 34}. • DELAY button When using the VOX or Break-in function, used for setting the time delay from transmit mode to receive mode {pages 31, 34}. !3 Mode buttons Press these buttons to select your operating mode {page 14}. • LSB/USB button Press to select lower sideband or upper sideband mode for voice or digital operation {pages 20, 27}. • CW/FSK button Press to select CW or frequency shift keying mode {pages 21, 26}. • FM/AM button Press to select FM or AM mode {page 22}. !4 MENU button Press to select or cancel the Menu mode that is used for activating and configuring functions {page 16}. !5 1MHz button Press to switch between the 1 MHz step mode and the Amateur band mode {page 29}. !6 Tuning control Turn to select the desired frequency {page 14}. Use the convenient finger-tip cavity for continuous tuning. The lever behind the control adjusts the control torque level; turn fully clockwise for light torque or fully counterclockwise for slightly heavy torque. 7