Kenwood VR-510 User Manual - Page 24
Operations, Normal playback, Preparing for playback, Listening to a source component
View all Kenwood VR-510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Normal playback Preparing for playback 24 Some preparatory steps are needed before starting playback. POWER ( ) INPUT MODE AUTO/CINEMA EQ. Listening to a source component VOLUME CONTROL INPUT SELECTOR Operations INPUT SELECTOR SPEAKERS A/B Selecting the input mode If you have selected a component connected to the CD/DVD, DVD/6ch, VIDEO2, or VIDEO3 jacks, make sure that the input mode setting is correct for the type of audio signal to be used. 7 Selecting MD/TAPE Select the source name corresponding to the component connected to the MD/TAPE jacks. The initial factory setting is "TAPE". To change the source to "MD", follow the steps below: 1 Use the INPUT SELECTOR knob to select "MD/TAPE". 2 Hold down the AUTO key for more than 2 seconds. • The source indication changes to "MD". • To return to the original indication, repeat procedure 2. Selecting the speaker system Press the SPEAKERS A or B key to select the speaker system to be used. A ON : Sound from the speakers connected to the SPEAKERS A terminals on the rear panel. B ON : Sound from the speakers connected to the SPEAKERS B terminals on the rear panel. No sound will be heard from the subwoofer. A+B ON : Sound from both the speakers connected to the SPEAKERS A and B terminals on the rear panel. A+B OFF : No sound from the speakers. Use this setting when listening with headphones for stereo sound in all playback modes. The indicator for the speakers you want to use should be lit. SP A B TI.VOL CLIP MUTE RDS EON PTY TP TA NEWS L CR LFE SW LS S RS • Selecting "6ch INPT" by pressing the INPUT MODE key, whereby "DVD/6ch" is the input source will cause SPEAKERS A to be selected automatically. • When you use the PRE OUT jacks, set only SPEAKERS A to ON mode. Turning on the receiver 1 Turn on the power to the related components. 2 Turn on the power to this receiver by pressing POWER ( ) or SYS. POWER ( ) key. MUSIC MOVIE VOL. 1 Use the INPUT SELECTOR knob, MUSIC key, or MOVIE key to select the source you want to listen to. The input sources change as shown below: Selecting a source using the INPUT SELECTOR knob 1 "PHONO" 2 "TUNER" 3 "CD/DVD" 4 "TAPE" or "MD" 5 "VIDEO1" 6 "VIDEO2" 7 "VIDEO3" 8 "DVD/6ch" 9 "AV AUX" Selecting a source using the MUSIC key 1 "CD/DVD" 2 "TAPE" or "MD" 3 "TUNER" 4 "PHONO" Selecting a source using the MOVIE key 1 "VIDEO1" 2 "VIDEO2" 3 "VIDEO3" 4 "DVD/6ch" 5 "AV AUX" • MUSIC and MOVIE will not display input sources which are not pre-setup. 2 Start playback from the selected source. 3 Use the VOLUME CONTROL knob or VOL. +/- keys to adjust the volume.